Does your older Toyota have a ton of blank switch panels and you want to add a phone mount or other accessories? This is a quick and simple solution for you!
Super simple install, Slide in the Ram Ball switch mount till it clips in place, use the provided Hex screw to tighten down the lock on the back of the mount until tight and you are done!
This design incorporates a lock on the ball mount itself so it can not spin loose after tightening no matter the angle.
Everything is included, the custom 3d printed Ram ball, The Switch mount, and the Hex key. It was designed around the Toyota Landcruiser switches but should work with any older Toyota with a flat switch blank.
3 variations are available, 0 wire cut out - just the Ball mount with hardware but no wire pass through 1 wire cut out - Ball mount with 1 wire pass through 2 wire cut out - Ball mount with 2 wire pass through
Currently designed to be compatible with all 1" ball mounts but other sizes will be available soon. Made from PETG, TPU, Brass and Steel
