95-97 LandCruiser Dash Accessory Mount V2

Maxflate Air Systems is proud to release the Version 2 of Dash Accessory Mount, or D.A.M for short. 

It is designed to fit 95-97 LandCruisers with the weird cut out in their dash above the radio that seems to serve no real purpose. This mount allows you to add a multitude of accessories but without the need to drill holes into all of the factory plastics or dashboard.

What is the difference between version 1 and version 2? Version 2 now includes D.A.M Locks or Ram Ball locks. These locks keep the Ram Ball from turning when heavier loads are applied at an angle. These locks are designed around the 1” Ram Tough Ball (Link) and come with supplied locking screws to secure everything in place. 

• Uses existing hardware for installation - no modification needed
• 3 brass ¼” x 20 threaded inserts to allow for most common ball mounts or other mounts
• 2 brass M4 x.7 threaded inserts for D.A.M Lock mount
• 2 black Hex screws
• Hex wrench included
• 3 top mount channels to route power or data cables - no more messy wires hanging down 
• Black to match dash and 3d printed from PETG 
• Comes with a lifetime warranty against material defects

The mount is made to order but usually ships out within 2 business days

**No ball mounts are included, this is only the base mount that goes into the dash**

When installing the locks, slide them over the Hex part of the Ram ball so they can spin freely. The locks are a tight fit and may take a little pressure to slide over the base of the Ram Ball, this is normal. Hand tighten the Ram Ball into the D.A.M then slide the lock back over the base of the Ram ball and adjust until the slot in the lock matches the M4 hole in the D.A.M. 

***TIP: If you are using all 3 Ram balls and locks, flip the middle lock upside down on the Ram Ball, this will allow both locks to sit flush and still secure the Balls on either side***

If you have any questions please feel free to reach out